A R Engineering

Batch Type Trickle Impregnating Machine

Batch Type Trickle Impregnating Machine

The best thing about our Batch Type Trickle Impregnating Machine is that it is suitable for pre-heating, trickling and post heating of stators. Moreover, it is simple to operate and compact in design. Maintaining our Batch Type Trickle Impregnating Machine for a long time is very easy. In addition to this, our Batch Type Trickle Impregnating Machine is ideal for carrying out following automatic cycle :

  • Load stators on spindles, connect winding wires, close the front door and start cycle with push button
  • Spindles start rotating and get pre-heated to predetermined temperature
  • Temperature of stator is sensed by non-contact TIC
  • Spindle holding plate is tilted up and varnish pipes are tilted down to adjust the place of trickling
  • Varnish pump starts and pre-determined varnish is trickled on stators / rotors and pump stops. Trickle Temperature is maintained with the non-contact TIC
  • Spindle holding plate is tilted down and varnish pipes are tilted up and post heating starts
  • After completing the post heating spindles, stop
  • Open the door & remove wire connections and Un-load the ready stators